SkrapinSask's First Air project(laysframeon26.6") <-- New

[SkrapinSask]

Well guys tonight i pulled my box so i can start dealing with all the useless factory components underneath





i also gotta deal with those nasty cab dents some time

[oldspice213]

oh yes that looks very familier haha

[SkrapinSask]

Put in a little time today after work. Pulled the shocks, fuel tank and un did the harness



Alright so how do you guys suggestme starting the air portion of my build? Finish the front and then build the rear off the lift/height of the front? do both at the same time?

[mazdaman82]

the best way to do something is to do it to the end, imo i thank you need to finish up the front first, befor you start on the rear

[MazdaDropped]

well first off take those ugly leaf springs off and ya finish the front unless your doing a full frame build

[SkrapinSask]

I was just waiting to plumb bob my axles so i have perfect center for my notches before i pulled the leafs!
I'll get the front finished up first!

[itslikewhooa]

I was told the little hole on the top of the frame was center point for the axle, because I didn't check mine before I ripped it off... anyway I'm planning on welding my notches in this sat, so if you check before that and its not center with that little hole, shoot me a message with the measurement to the center point, so I get mine in the right spot thanks man.

[SkrapinSask]

i will let you know if its at that hole or the distance it is from the hole!

[paparoach1983]

SONDS LIKE YOU MOVING PRETTY DECENT PASE

[mazdamandan]

is that a secondary proportioning valve bolted behind the pass side rear tire?
i didnt have that , what year and body is this?

Its always exciting when the box is exposed!!

[mazdaman82]

is that a secondary proportioning valve bolted behind the pass side rear tire?
i didnt have that , what year and body is this?

Its always exciting when the box is exposed!!

its abs some of these truck had it and some didn't

[SkrapinSask]

possile to eliminate the abs box? or do most of you guys just rebend custom hardlines to it?

[elbine69]

You can get rid of it. Its pretty much worthless anyways.

[SkrapinSask]

pretty much ready to be welded up

[itslikewhooa]

looks good... nice and clean